Mast Step Fabrication/machining

Moderators: Shu, rand

Post Reply
mwattsi14
Posts: 29
Joined: Mon Jun 28, 2010 4:17 pm

Mast Step Fabrication/machining

Post by mwattsi14 » Wed Oct 02, 2013 8:03 am

Hi Guys.

I am trying to get a new mast step made up as the old one is a poor fit in the new rig.

Anyone got any recommendations for someone that can machine acetyl at a reasonable cost? Or other approaches to creating a new mast step. The mast sits inside an oversize tube with a metal bar across as the bearing point. So its a relatively simple circular mast step with a channel cut into it.

Hope to be back on the circuit in Weymouth after far too long away from the I14!

Cheers

Mark
GBR 1506
Mark Watts
GBR 1534

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest